17695 Exposure Head HEAD: LV Positive 12V fault (bipolar) All Note that due to a programming error, this error has been defined for both the green and thermal heads. Thermal: LV Positive 12V fault (bipolar). Only for bipolar LV driver boards which never shipped so this error should never occur. A power supply / hardware failure is required to generate this error. As a result, it is unlikely that this error will be recorded by any machine. This error code applies to Thermal Head firmware versions 1.21 to 1.32. Green: tilter actuator did not initialize The exposure head's tilter actuator did not initialize properly. Imaging and other head operations will likely not work properly. Check all power supplies on the head. If these do not seem to be the problem, contact head integration for advice. Thermal: Call service. Green: Record error message and contact Creo Service Thermal: Power supply / hardware failure. Green: Head power supplies out of spec. Green: Actuator mechanism faulty ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:33:42 2008 PST